Re: [coreboot] Asus KGPE-D16 with latest coreboot errors with Unsupported Hardware on Qubes 4 install missing IOMMU?

Please keep replies on the list - I will notice them - and like I said I
won't give up until it works :D

I wish you had OpenBMC installed so that I could access your system
remotely and try stuff myself (via VPN and a router IP whitelist for
security ofc)

Did your D16 come with an ASMB4 or ASMB5 module? if so I recommend
installing OpenBMC and its coreboot patches - note that coreboot needs
patching for them to play nice together since for some stupid reason the
required patches have not been upstreamed so you would need to cherry-pick.

I am using v4.6 on my system FYI (no reason for me to update) and the
only options I have changed are the ones I told you about before...all I
can figure is perhaps I have a different version of the SP5100 that
doesn't have the erratum or something to that effect.

FYI I saw you select build nvramcui as a secondary payload so you can
mess with cmos options without recompiling as long as next time you shut
off "Load default configuration values into CMOS on each boot"

Since your menuconfig options look fine...shot in the dark but try using
grub instead of SeaBIOS as I use grub.

Asus KGPE-D16 with latest coreboot errors with Unsupported Hardware on Qubes 4 install missing IOMMU?

[petecb]

Hi Taiidan,

Thanks for your message.
> I am using v4.6 on my system FYI (no reason for me to update) and the
> only options I have changed are the ones I told you about before...all I
> can figure is perhaps I have a different version of the SP5100 that
> doesn't have the erratum or something to that effect.

Is it possible for me to build v4.6 in case something has changed since then that causes my issues? When I look at the branches available on git there is no 4.6 available.
> FYI I saw you select build nvramcui as a secondary payload so you can
> mess with cmos options without recompiling as long as next time you shut
> off "Load default configuration values into CMOS on each boot"
>
> Since your menuconfig options look fine...shot in the dark but try using
> grub instead of SeaBIOS as I use grub.

I will try building it with Grub. There is an option to include a GRUB2 runtime config file into ROM image. Should I select this? If so, what options should be in this file?

Kind regards,

Pete