Howdy folks,
I have gotten Linuxbios to run on my tyan s2895 board to the
point that I am
Reading the kernel image off of the hard drive. At this point, I crash. I would like to
Know where are the Linux Kernel patches to apply to make this work correctly.
Well it would help to know what kernel you are trying to load. *grin* What devices you have enabled. Perhaps the serial log of the boot, etc...
There are not any "official" kernel patches as it all depends on what hardware you have and what you are trying to do.
I don't use that hardware but in 99% of the cases the kernel crash is due to linuxbios not setting something up like the factory bios does.
First you need to load a memtest payload and verify your RAM is working 100%.
-- Richard A. Smith