Re: HDAMA status

[YhLu]

Ron,

I have checked the mptable.c and irq_table.c for hdama. They seem got some
problem.

And you maybe need to re-produce the two files.

Regards

Yinghai Lu

-----邮件原件-----
发件人: ron minnich [mailto:[e-mail]] 
发送时间: 2003年8月5日 10:46
收件人: [e-mail]
主题: HDAMA status

currently, I'm having PIRQ routing problems.

Etherboot loads the kernel just fine, and here's something very odd: 
etherboot says the two MACs are at 1:3.0 and 1:4.0; the kernel says the 
macs are at 2:3.0 and 2:4.0.

This is odd. Any one out there have a simple explanation for me?

Also the PIRQ in the CVS looked quite wrong, but dumping the PIRQ from a 
running BIOS and using that fails as well.

I've gone so far as to have LinuxBIOS just jam the same interrupts the 
standard bios uses by doing this in mainboard/arima/hdama/mainboard.c

static void
enable(struct chip *chip, enum chip_pass pass)
{

struct mainboard_arima_hdama_config *conf =
                (struct mainboard_arima_hdama_config *)chip->chip_info;

switch (pass) {
        default: break;
        case CONF_PASS_PRE_BOOT:
        {
                struct device *p;
                /* PIRQ is still wrong. Just set ethernet for now */
                p = dev_find_slot(1, 0x18);
                pci_write_config8(p, 0x3c, 0xb);
                p = dev_find_slot(1, 0x20);
                pci_write_config8(p, 0x3c, 0xb);
                printk_err("JAM ethernet to IRQ 11!\n");
                break;
        }
        }

}

But it didn't help at all. I also tried doing the same crude thing to
device 2:3.0 but that did not help.

This business of the gige appearing on different busses is very odd; any 
explanation here?

Hints welcome :-)

ron

_______________________________________________
Linuxbios mailing list
[e-mail]
http://www.clustermatic.org/mailman/listinfo/linuxbios