it is part of the result of booting linux bios on my epia board
but i'm not sure I'm doing right........... it's almost end of it...........
Wrote linuxbios table at: 00000500 - 0000068c checksum a514
Welcome to elfboot, the open sourced starter. January 2002, Eric Biederman. Version 1.2
37:init_bytes() - zkernel_start:0xfff00000 zkernel_mask:0x0000ffff Found ELF candiate at offset 0 New segment addr 0x94000 size 0x7328 offset 0x60 filesize 0x37e0 (cleaned up) New segment addr 0x94000 size 0x7328 offset 0x60 filesize 0x37e0 Loading Segment: addr: 0x0000000000094000 memsz: 0x0000000000007328 filesz: 0x00Clearing Segment: addr: 0x00000000000977e0 memsz: 0x0000000000003b48 Jumping to boot code at 0x94000 ROM segment 0xffff length 0xfffe reloc 0x9400 Etherboot 5.0.8 (GPL) Tagged ELF for [VIA 86C100] Boot from (N)etwork or from (L)ocal? clocks_per_tick = 504391 N Probing...[VIA 86C100]Found VIA 6102 ROM address 0x0000 rhine.c v1.0.0 2000-01-07 IO address 1800 Ethernet Address: 00:40:63:CB:C8:11 Analyzing Media type,this will take several seconds........OK Linespeed=100Mbs Halfduplex The PCI BIOS has not enabled this device! Updating PCI command 0003->0007. pci_bus 00 pci_device_fn 90 Searching for server (DHCP)... ..................
_________________________________________________________________ 보다 빠르고 보기 편한 뉴스. 오늘의 화제는 MSN 뉴스에서 확인하세요. http://www.msn.co.kr/news/
On Fri, 25 Jul 2003, gimyung han wrote:
Updating PCI command 0003->0007. pci_bus 00 pci_device_fn 90 Searching for server (DHCP)... ..................
we saw this too. It looks like etherboot trouble.
did you snoop the network to see if packets are getting out?
ron
Hi,
It is working, but you need to setup dhcpd and tftp server.
-Andrew
On Fri, Jul 25, 2003 at 04:03:50AM +0000, gimyung han wrote:
it is part of the result of booting linux bios on my epia board
but i'm not sure I'm doing right........... it's almost end of it...........
Wrote linuxbios table at: 00000500 - 0000068c checksum a514
Welcome to elfboot, the open sourced starter. January 2002, Eric Biederman. Version 1.2
37:init_bytes() - zkernel_start:0xfff00000 zkernel_mask:0x0000ffff
Found ELF candiate at offset 0 New segment addr 0x94000 size 0x7328 offset 0x60 filesize 0x37e0 (cleaned up) New segment addr 0x94000 size 0x7328 offset 0x60 filesize 0x37e0 Loading Segment: addr: 0x0000000000094000 memsz: 0x0000000000007328 filesz: 0x00Clearing Segment: addr: 0x00000000000977e0 memsz: 0x0000000000003b48 Jumping to boot code at 0x94000 ROM segment 0xffff length 0xfffe reloc 0x9400 Etherboot 5.0.8 (GPL) Tagged ELF for [VIA 86C100] Boot from (N)etwork or from (L)ocal? clocks_per_tick = 504391 N Probing...[VIA 86C100]Found VIA 6102 ROM address 0x0000 rhine.c v1.0.0 2000-01-07 IO address 1800 Ethernet Address: 00:40:63:CB:C8:11 Analyzing Media type,this will take several seconds........OK Linespeed=100Mbs Halfduplex The PCI BIOS has not enabled this device! Updating PCI command 0003->0007. pci_bus 00 pci_device_fn 90 Searching for server (DHCP)... ..................
º¸´Ù ºü¸£°í º¸±â ÆíÇÑ ´º½º. ¿À´ÃÀÇ ÈÁ¦´Â MSN ´º½º¿¡¼ È®ÀÎÇϼ¼¿ä. http://www.msn.co.kr/news/
Linuxbios mailing list Linuxbios@clustermatic.org http://www.clustermatic.org/mailman/listinfo/linuxbios
On Fri, 25 Jul 2003, Andrew Ip wrote:
It is working, but you need to setup dhcpd and tftp server.
I think he should snoop the network to make sure dhcp packets are getting off the board.
ron