IMB-A180E H coreboot won't boot

[Mark C. Mason]

I'm new to coreboot, and I'm working to use it with an ASROCK IMB-A180,
the H version with the LVDS port.

I've read previous posts regarding the "IMB-A180 won't boot" on this group,
and tried the .config that was posted, but the result is the same.

The debugging output shows things progressing until agesawwrapper_amdinitmid
is called, then the boot restarts, then stops cold at the same point:

PCI: 00:18.4
        PCI: 00:18.5
     Done allocating resources.
     BS: BS_DEV_RESOURCES times (us): entry 0 run 1095130 exit 0
     POST: 0x74
     Enabling resources...

Fam16 - domain_enable_resources: AmdInitMid.
     agesawrapper_amdinitmid 
^@^@^@^@§H¨Hh½É<95><89>½½Ñµ4.0-5169-g9d1d740 Tue Feb 4     16:46:38 PST 
2014 starting...

Any help with this would be greatly appreciated.  Full serial debug 
output then .config are attached below.

Best regards,

Mark Mason
Engineering Design Team

[WANG Siyuan]

Hi,Mark Mason
Have you resolved this issue? Maybe you can uncomment
     #define IDSOPT_TRACING_ENABLED TRUE
    in src/mainboard/asrock/imb-a180/OptionsIds.h. Then you can get more
debug message in Agesa.
Try to debug into AmdInitMid()
in src/vendorcode/amd/agesa/f16kb/Proc/Common/AmdInitMid.c to see where the
problem is.

Yours sincerely,
WANG Siyuan

On Sat, Feb 8, 2014 at 2:23 AM, Mark C. Mason  wrote:
> I'm new to coreboot, and I'm working to use it with an ASROCK IMB-A180,
> the H version with the LVDS port.
>
> I've read previous posts regarding the "IMB-A180 won't boot" on this group,
> and tried the .config that was posted, but the result is the same.
>
> The debugging output shows things progressing until
> agesawwrapper_amdinitmid
> is called, then the boot restarts, then stops cold at the same point:
>    PCI: 00:18.4
>    PCI: 00:18.5
> Done allocating resources.
> BS: BS_DEV_RESOURCES times (us): entry 0 run 1095130 exit 0
> POST: 0x74
> Enabling resources...
>
> Fam16 - domain_enable_resources: AmdInitMid.
> agesawrapper_amdinitmid ^@^@^@^@佚沈h褕<95><89>蝸捄4.0-5169-g9d1d740 Tue
>
> Feb 4     16:46:38 PST 2014 starting...
>
> Any help with this would be greatly appreciated.  Full serial debug output
> then .config are attached below.
>
> Best regards,
>
> Mark Mason
> Engineering Design Team