RE: Irq_table not loaded when boot from etherboot

[Lawrence LL. Dai]

Hi,

I have dumped the two files from my system, but I still have several puzzles:

1. How can replace the "conforms" with "MP_IRQ_TRIGGER_EDGE|MP_IRQ_POLARITY_HIGH" in the mptable.c? Should I ask the hardware Engineer for help?

2. Shall I change following strings in mptable.c to instruction as "smp_write_intsrc(mc, mp_NMI, conforms|conforms, 0x0, 0x0, MP_APIC_ALL, 0x1)" ? If should, how can I do this?
MP Config Extended Table Entries:
--
System Address Space
 bus ID: 0 address type: I/O address
 address base: 0xc000
 address range: 0x3000

Could you help me to check the files attached? Please teach me how to fix them.

Best Regards,
Lawrence

-----Original Message-----
From: Ronald G. Minnich [mailto:[e-mail]] 
Sent: 2003?1?17? 23:06
To: Lawrence LL. Dai
Cc: [e-mail]
Subject: Re: Irq_table not loaded when boot from etherboot

either you PIRQ table or your MPTABLE or both are wrong. You will need to 
fix this.

ron