Hi,
I have dumped the two files from my system, but I still have several puzzles:
1. How can replace the "conforms" with "MP_IRQ_TRIGGER_EDGE|MP_IRQ_POLARITY_HIGH" in the mptable.c? Should I ask the hardware Engineer for help?
2. Shall I change following strings in mptable.c to instruction as "smp_write_intsrc(mc, mp_NMI, conforms|conforms, 0x0, 0x0, MP_APIC_ALL, 0x1)" ? If should, how can I do this? MP Config Extended Table Entries: -- System Address Space bus ID: 0 address type: I/O address address base: 0xc000 address range: 0x3000
Could you help me to check the files attached? Please teach me how to fix them.
Best Regards, Lawrence
-----Original Message----- From: Ronald G. Minnich [mailto:rminnich@lanl.gov] Sent: 2003?1?17? 23:06 To: Lawrence LL. Dai Cc: linuxbios@clustermatic.org Subject: Re: Irq_table not loaded when boot from etherboot
either you PIRQ table or your MPTABLE or both are wrong. You will need to fix this.
ron