Hi, I was hoping someone could help me out or point me in the right direction with a tyan s2912-e board not booting with coreboot, 2x 2419 opterons 16GB ECC DDR2 RAM Onbard SAS LSI 1064e AMD Radeon 7850 2GB
the codes on the onboard POST display (from port 80) are changing so fast that I cannot make them out however it is seems by the pattern of codes outputted that it is in a loop, are there any particular settings in the menuconfig that are required? Or have I missed something obvious?
The system flashes with flashrom no problem I have tried booting with 1 CPU and just 1 stick of RAM, removed the PCIe GFX card. I have also built coreboot with and without the onboard VGA bios but none of this makes any difference, any help would be greatly appreciated.
-
Mark Mc