Here is how FILO 0.6.0 is booting:
ahci: Found SATA controller 00:11.00 (1022:7801) <--- this is AMD SATA AHCI controller, built-in inside Bolton A76M FCH Southbridge of Lenovo G505S ahci: ATA drive on port #1. ata: Identified [my 1TB HDD drive model here] ahci: ATAPI drive on port #2. atapi: Identified [my DVD drive model here] ERROR: No such CMOS option (boot_devices)
Then it shows FILO screen with " root_dev = unset " message and FILO command line
=== QUESTION ===
Please could you give some good examples about how to use FILO ? Do I have to set boot_devices in CMOS through nvramcui payload, or it is possible to choose that root_dev in FILO - if yes, how?
I tried some random commands like filo> kernel hda:/vmlinuz but it tells: Disk read error dev=1 drive=0 sector=0 Disk read error dev=1 drive=0 sector=2 Disk read error dev=1 drive=0 sector=2 Disk read error dev=1 drive=0 sector=128 Disk read error dev=1 drive=0 sector=16 Disk read error dev=1 drive=0 sector=64 Disk read error dev=1 drive=0 sector=0 Disk read error dev=1 drive=0 sector=64 Disk read error dev=1 drive=0 sector=0 Disk read error dev=1 drive=0 sector=0 Unknown filesystem type.
Error 15: Filo not found.
https://www.coreboot.org/FILO is too basic - e.g. does not tell how to check the list of available devices. When I run "probe" command it only tells 6 messages "IDE channel X not found" (with X changing 0,0,1,1,2,2,3,3) - does not show SATA drive, despite I know that it successfully initialized, because it output its model and brand
Please give any real world FILO usage examples with a modern Linux, it will help a lot!
Best regards, qmastery
-
qma ster