Hi all,
Signed-off: Marc Bertens <mbertens(a)xs4all.nl>
Tested-by: Marc Bertens<mbertens(a)xs4all.nl>
I made some new patches for the Nokia IP530, therefore my last patch
submission can be discarded.
1. 21143PD driver; I removed the not needed stuff from there and
tested without and all worked fine.
2. Patched the devicetree.cb; added some comments and commented out
the setting of the GPIO lines, this was unnecessary.
3. nokia/Kconfig; added a description in de help about which board
revisions are supported.
4. ip530/Kconfig; added the CPU model, removed the PIRQ_ROUTE and set
the IRQ_SLOT_COUNT to 1, this last is needed by the
header files, because those structures are still used by the
code, see pirq_table.c
5. ip530/mainboard.c; Now the identification of the physical system
is show in the boot up of the machine, like;
* System type, should be IP530, otherwise a warning is given.
* Board number
* Mfg. P/N
* Mfg. rev.
* Serial number
All these read from the SPI eeprom behind the SuperIO
6. The sourcecode files for the superIO-SPI interface in the
Nokia-IP530.
Stefan: please drop that last patch submission of mine.
Thats all folks....
Marc