I have KGPE-d16 with IOMMU/AMD-VI and I was wondering if it would be possible to designate in coreboot certain devices pass-through only to stop them from communicating with the host? If I have to launch a rescue CD or what not then a rogue infected device could do a DMA attack correct?
On linux does iommu only isolate from the host devices assigned to a guest? assigned to pcistub? or is there always some level of mediation? My system says "dom0 mode - relaxed" right below the AMDVI messages, what does it mean?
Thanks for any replies!
-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1
On 11/15/2016 03:35 PM, Taiidan@gmx.com wrote:
I have KGPE-d16 with IOMMU/AMD-VI and I was wondering if it would be possible to designate in coreboot certain devices pass-through only to stop them from communicating with the host? If I have to launch a rescue CD or what not then a rogue infected device could do a DMA attack correct?
On linux does iommu only isolate from the host devices assigned to a guest? assigned to pcistub? or is there always some level of mediation? My system says "dom0 mode - relaxed" right below the AMDVI messages, what does it mean?
Thanks for any replies!
Coreboot does not currently configure the IOMMU to reject unauthorized access; it waits for Linux to start and configure the IOMMU. By default, Linux configures the IOMMU (if present) to only accept access to authorised areas of memory*, therefore once Linux starts exploiting the system via PCI becomes very difficult. If you have passed any options to Linux regarding the IOMMU (e.g. iommu=soft or iommu=pt), the system may have lost this protection, so be careful!
It might be an interesting experiment to configure the IOMMU from within coreboot in order to close the small window where a malicious PCI device could attack the host. This is something we'd be willing to consider under contract if there's interest.
I hope this helps!
* Both Raptor and other KGPE-D16 users have seen this in action with rogue cards -- in particular, one USB 3 card with firmware blobs attempted to scan host memory. When a peripheral misbehaves in this manner, you will see messages similar to:
"AMD-Vi: Event logged [IO_PAGE_FAULT device=00.00.0 domain=0x0000 address=0x0000000000000000 flags=0x0000]"
Each one of those is a peripheral access to main memory that has been blocked by the IOMMU. If you see a lot of these, especially if they continue to be generated after bootup, you probably have a buggy or malicious PCI device installed.
- -- Timothy Pearson Raptor Engineering +1 (415) 727-8645 (direct line) +1 (512) 690-0200 (switchboard) https://www.raptorengineering.com
-
Taiidan＠gmx.com -
Timothy Pearson