Hi,
Need a bit of help with this.
I have rolled and flashed a coreboot rom to the above motherboard, and after a reboot (soft) my video bios flashed up a few times and I sucessfully made the SeaBIOS prompt. However since then I have not had video. I grabbed the serial console and found that coreboot seems to be hanging before any posts are issued, but it seems never in the same place.
I have attached the furthest it seems to get and the latest cold boot I've attempted - I hope they help.
The specs of the machine are: 768mb ( 3 x 256mb pc133), a ATI 3d Rage in the AGP slot, and a Piii 700e (100mhz) on a flipchip (MS6905). I removed all other cards trying to debug this.
I'm wondering if I made a mistake in the rom so I've attached the config file too.
Can anyone explain what is happening here?
Regards,
Steve
Lundie wrote:
I have rolled and flashed a coreboot rom to the above motherboard, and after a reboot (soft) my video bios flashed up a few times and I sucessfully made the SeaBIOS prompt. However since then I have not had video.
..
The specs of the machine are: 768mb ( 3 x 256mb pc133), a ATI 3d Rage in the AGP slot, and a Piii 700e (100mhz) on a flipchip (MS6905). I removed all other cards trying to debug this.
I'm wondering if I made a mistake in the rom so I've attached the config file too.
The problem is likely with the code, not with your config.
Can anyone explain what is happening here?
Unclear, in which case it is usually a matter of RAM init not being completely correct.
It would also be interesting to try with different graphics cards, and without any graphics card at all.
Further it would be interesting to try all different combinations of your 3 PC133 DIMMs. Start with one, move it around every slot, and so on.
Always capture serial output for each test.
//Peter
-
Lundie -
Peter Stuge