[LinuxBIOS] MSI interrupts

[Thomas Ekstrand]

Hi!

I have this error:
--snip--
tg3: eth0: No interrupt was generated using MSI, switching to INTx mode. Please
report this failure to the PCI maintainer and include system chipset
information.
tg3: eth1: No interrupt was generated using MSI, switching to INTx mode. Please
report this failure to the PCI maintainer and include system chipset
information.
--snip--

How can I get the interrupt to go through MSI?
Currently there are no interrupts at all.
I'm running on broadcom blast based board with the bcm5780/5785 chipset

regards
Thomas

[yhlu]

1. Blast based, what doesn't mean?
2. your broadcom is PCIX or PCI-E?

YH

On 5/30/07, Thomas Ekstrand  wrote:
> Hi!
>
> I have this error:
> --snip--
> tg3: eth0: No interrupt was generated using MSI, switching to INTx mode. Please
> report this failure to the PCI maintainer and include system chipset
> information.
> tg3: eth1: No interrupt was generated using MSI, switching to INTx mode. Please
> report this failure to the PCI maintainer and include system chipset
> information.
> --snip--
>
> How can I get the interrupt to go through MSI?
> Currently there are no interrupts at all.
> I'm running on broadcom blast based board with the bcm5780/5785 chipset
>
> regards
> Thomas

[Thomas Ekstrand]

1. custom board based on the broadcom blast.
2. via PCIX bridge internally in the ht2000

Thomas

2007/5/30, yhlu :
> Blast based, what doesn't mean?
> your broadcom is PCIX or PCI-E?
>
> YH
>
> On 5/30/07, Thomas Ekstrand  wrote:
> > Hi!
> >
> > I have this error:
> > --snip--
> > tg3: eth0: No interrupt was generated using MSI, switching to INTx mode. Please
> > report this failure to the PCI maintainer and include system chipset
> > information.
> > tg3: eth1: No interrupt was generated using MSI, switching to INTx mode. Please
> > report this failure to the PCI maintainer and include system chipset
> > information.
> > --snip--
> >
> > How can I get the interrupt to go through MSI?
> > Currently there are no interrupts at all.
> > I'm running on broadcom blast based board with the bcm5780/5785 chipset
> >
> > regards
> > Thomas

[yhlu]

On 5/31/07, Thomas Ekstrand  wrote:
> custom board based on the broadcom blast.
> via PCIX bridge internally in the ht2000

do you change anything with BLAST code in the tree?

the NIC should work, and only some problem with sata, but someone sent
patch for sata already. or merged?

YH

[bxshi]

> the NIC should work, and only some problem with sata, but someone sent
> patch for sata already. or merged?

yes. Sata is Ok for broadcom/bcm5785.

bxshi