Hi! You need to enable writing to the flash. In case of the Iwill board, some SuperIO GPIOs need to be properly set. I sent an email to the list with a patch attached, which configures flashrom to handle the iwill dk8_htx correctly.
Regards, Mondrian
Hi,Mondrian
Thats great! I will search for your posts. Thank you very much!
Best, Ning
On 4/25/07, Mondrian Nuessle nuessle@uni-mannheim.de wrote:
Hi! You need to enable writing to the flash. In case of the Iwill board, some SuperIO GPIOs need to be properly set. I sent an email to the list with a patch attached, which configures flashrom to handle the iwill dk8_htx correctly.
Regards, Mondrian
-- Mondrian Nuessle University of Mannheim Phone: +49 621 181 2717 Computer Architecture Group Fax: +49 621 181 2713 http://ra.ti.uni-mannheim.de mailto:nuessle@uni-mannheim.de
Hi, Mondrian,
Unfortunately, after patching flashrom, the results remain the same as before. Only the page 7 is programmed. I guess I should first check the WP pin of Savior, and then perhaps I need this patch to program it. Thanks for your help!
Best, Ning
On 4/25/07, Mondrian Nuessle nuessle@uni-mannheim.de wrote:
Hi! You need to enable writing to the flash. In case of the Iwill board, some SuperIO GPIOs need to be properly set. I sent an email to the list with a patch attached, which configures flashrom to handle the iwill dk8_htx correctly.
Regards, Mondrian
-- Mondrian Nuessle University of Mannheim Phone: +49 621 181 2717 Computer Architecture Group Fax: +49 621 181 2713 http://ra.ti.uni-mannheim.de mailto:nuessle@uni-mannheim.de
-
Mondrian Nuessle -
Ning (Michael) Qu