Actually, for OpenBMC work, hotplugging is often the only way to go.
Just be very careful to align the pins correctly the first time; you
don't have a second chance if you misalign the pins and fry the module...
On 02/22/2018 03:22 PM, Taiidan(a)gmx.com wrote:
On 02/17/2018 09:46 AM, Elisenda Cuadros wrote:
Now I trying to use your OpenBMC port.
I followed the instructions and everything was fine (compiling,
reading and flashing). I waited several minutes after flashing, but
the module didn 't blinked like in the vendor rom, nor did it receive
I halted the system because I thought maybe it needs a cold start.
After this, the system doesn't boot with the module plugged in. The
fans begin to spin for approximately 1/4 second, but nothing else.
My two fans (1 cpu & 1 chassis) have 3 pins and are low speed (~1000rpm)
In the case I have to reflash the module, is it possible to hotplug it?
Hotplugging is dangerous and not supported, don't do it.
Thank you very much for your support.
can use a test clip to externally flash it via a flashing device
(not sure which can do 16 pins though, I would inquire on the flashrom
Are you using the latest coreboot? AFAIK coreboot was patched to support
OpenBMC, so you need a new version with the patches.
+1 (415) 727-8645 (direct line)
+1 (512) 690-0200 (switchboard)