Actually if others of you want to contribute, there is this heads kgpe-d16 port that permits to flash directly from the heads coreboot payload with Timothy's patches on the flashrom tools. You may want to take a look here :

Le jeu. 22 févr. 2018 16:37, Timothy Pearson <> a écrit :
Actually, for OpenBMC work, hotplugging is often the only way to go.
Just be very careful to align the pins correctly the first time; you
don't have a second chance if you misalign the pins and fry the module...

On 02/22/2018 03:22 PM, wrote:
> On 02/17/2018 09:46 AM, Elisenda Cuadros wrote:
>> Hi,
>> Now I trying to use your OpenBMC port.
>> I followed the instructions and everything was fine (compiling,
>> reading and flashing). I waited several minutes after flashing, but
>> the module didn 't blinked like in the vendor rom, nor did it receive
>> an ip.
>> I halted the system because I thought maybe it needs a cold start.
>> After this, the system doesn't boot with the module plugged in. The
>> fans begin to spin for approximately 1/4 second, but nothing else.
>> My two fans (1 cpu & 1 chassis) have 3 pins and are low speed (~1000rpm)
>> In the case I have to reflash the module, is it possible to hotplug it?
> Hotplugging is dangerous and not supported, don't do it.
>> Thank you very much for your support.
> You can use a test clip to externally flash it via a flashing device
> (not sure which can do 16 pins though, I would inquire on the flashrom
> mailinglist)
> Are you using the latest coreboot? AFAIK coreboot was patched to support
> OpenBMC, so you need a new version with the patches.

Timothy Pearson
Raptor Engineering
+1 (415) 727-8645 (direct line)
+1 (512) 690-0200 (switchboard)

coreboot mailing list: