Nope, not "console=/dev/ttyS0,115200n8" you want "console=ttyS0,115200n8" (or you can leave out the n8). Give that a shot. But first, as the last mail said, test it under a normal bios (with the same command line!).
On Sat, 6 Sep 2003, rimy2000 wrote:
Yes, I put.
./mkelfImage --kernel=/mnt/root/bzImage-17 --output=vmlinuz.vo --command-line="c onsole=/dev/ttyS0,115200n8 root=/dev/hda2"
----- Original Message ----- From: "Adam Agnew" agnew@cs.umd.edu To: "rimy2000" rimy2000@hotmail.com Cc: linuxbios@clustermatic.org Sent: Saturday, September 06, 2003 11:38 AM Subject: Re: about etherboot and mkelfImage
Did you put this on your command like "console=ttyS0,115200" (change 115200 for the baud you were using linuxbios at)?
On Sat, 6 Sep 2003, rimy2000 wrote:
After I upgrade binutils to 2.14, mkelfImage 2.5 work find and the new output is
Loading 172.27.4.23:vmlinuz.vo ...(ELF)... .......................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................done
rhine disable
Firmware type: LinuxBIOS
but then I received nothing from serial.
Any hint?
Thanks!�
Linuxbios mailing list Linuxbios@clustermatic.org http://www.clustermatic.org/mailman/listinfo/linuxbios
Linuxbios mailing list Linuxbios@clustermatic.org http://www.clustermatic.org/mailman/listinfo/linuxbios