On Wed, Jun 24, 2009 at 6:36 AM, Arnaud Mayearnaud.maye@4dsp.com wrote:
I've tried a reverse engineer approach. Plug a DIMM into the system and launch Linux with the legacy BIOS. lspci -xxx then shows me the IMCH BAR and implicitly the settings doctored by the legacy BIOS. The first try I've done was to try the r-e DRT0/DRT1 in the coreboot RAM init code. Not much differences so far. But anyway I've seen quite a lot of difference around the ODT register and such. So there is still some hope.
Have you tried 2T timing? This causes the memory controller to wait an extra cycle before sending a command. The delay can compensate for slight misconfiguration of other signal timing settings so it's a good place to start.
Also try different RCOMP values. I have no idea what RCOMP is but I remember having to tweak it to get the memory to behave.
--Ed