Re: jmp INSTRUCTION IN boot.c fails and resets again , what could be the reason.

I have enabled RAMTEST(ramtest.inc) in the LinuxBIOS, it seems to be running at
a very slow pace.Hope it finishes off by today.
*****Extract*****
dump northbridge:
00: 86 80 24 71 06 00 80 00 03 00 00 06 00 00 00 00
10: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
20: 00 00 00 00 00 00 00 00 00 00 00 00 86 00 24 00
30: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
40: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
50: 28 53 09 3c 00 00 00 00 00 00 00 00 00 00 00 00
60: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
70: cc 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
80: c6 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
90: 00 00 eb fb 00 00 00 00 00 00 00 00 00 00 00 00
a0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
b0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
c0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
d0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
e0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
f0: 00 00 00 00 00 00 00 00 00 00 00 00 00 01 00 00
Done.
Testing SDRAM : 80000a00-ffff0f30
SDRAM fill:
887e0000
*****Extract*****

The number(887?????) increments at a very slow pace and has
been more than an hour now. Moreover, I have 64MB ram, 
does the above range of test look OK.
If has basically happened after changing some parameter
in the North Bridge.
I have run ramtest before as well without the changes.

****Extract Before *****
Testing SDRAM : 00000000-0009ffff
SDRAM fill:
000000000001000000020000000300000004000000050000000600000007000000080000000900000009ffff
SDRAM verify:
000000000001000000020000000300000004000000050000000600000007000000080000000900000009ffff
Done.
****Extract Before *****
But in this case also, it used to reset...
I hope, this what is expected in the Successful Output of Ramtest.

Any pointers on this one.

Regards
Deepak