Hi //Peter
Why the restrictions on who you can sell to ?
How about US consumers ? You didn't mention them on your page ?
Bob
----- Original Message ----- From: "Peter Stuge" peter@stuge.se To: coreboot@coreboot.org Sent: Thursday, July 17, 2008 1:21 PM Subject: Re: [coreboot] GA-M57SLI-S4 rev 2.0 dual flash chip modificationrecipe
When testing a modified board a while back I discovered that I had forgoten one important ingredient and step in this recipe. I've just updated http://stuge.se/m57sli/ and added a photo of the finished mod while I was at it.
On Sun, Jun 22, 2008 at 07:24:45AM +0200, Peter Stuge wrote:
For the better modification, you also need: 2x 0402 4k7 chip resistors (1k is OK too, 10k does not work!) 2x 0603 100k chip resistors 2x SOT-23 BC847C transistors
Add:
1cm AWG 30 wire (but get some extra so there is some to work with)
Better: NOTE: Switch wires can be rather long. Several meters has been tested. 4. R90,R91: Populate 0402 4k7 resistors
Insert:
- Q2,Q43: Solder 5mm or so of AWG 30 wire between Q2-2 and Q2-3. Solder another wire between Q43-2 and Q43-3.
I am happy to sell boards pre-modified with the better modification. Unfortunately I cannot offer these boards to consumers in all EU member states because of EU environmental regulations, but many are OK.
I've made a table showing which states I can sell to on the web page too.
//Peter
-- coreboot mailing list coreboot@coreboot.org http://www.coreboot.org/mailman/listinfo/coreboot