Re: [coreboot] Stepping in boot code of DB800 via JTAG

[llandre]

The technical support from mips.com helped me to solve the problem. It 
is necessary to issue the following command first:

config disabletrace on

Regards,
llandre

DAVE Electronics System House - R&D Department
web:   http://www.dave.eu
email: r&[e-mail]
> llandre wrote:
> > I successfully booted the DB800 evaluation board with coreboot v2, 
> > however I can't step the boot code via JTAG (FS2 System Navigator).
> > Following is the console dump.
> > Anybody experienced the same problem?
>
> llandre,
>
> I think you need to halt before you step. On a reset the CPU runs unless 
> you put it into debug stall via the bootstrap options. See 
> GLCP_SYS_RSTPLL 4C000014h.
>
> Marc