Re: [coreboot] 回复: Advice how to install Linux to get it working with FILO

[Joop Boonen]

On Wed, May 19, 2010 1:46 am, [e-mail] wrote:
> Hi
> Grub command is fine, what is your problem about filo?  send the log if
> you can

The problem is that I see the follwoing in the log:

<quote>
Jumping to entry point...

INIT detected from  --- { APICID = 00 NODEID = 00 COREID = 00} ---

Issuing SOFT_RESET...
</quote>

I've also attached the log.
> Wang Qing Pei
> Mail: [e-mail]
> Phone:86+013426369984
>
> ----- Reply message -----
> 发件人： "Joop Boonen" 
> 日期： 周三, 5 月 19 日, 2010 年 07:09
> 主题： [coreboot] Advice how to install Linux to get it working with
> FILO
> 收件人：
>
> Hello All,
>
> I want to get FILO working on my system (arima/hdama).
> As I want to rule out my Linux installation I have a few questions.
> I've installed openSuSE 11.2 x86_64 on a SATA disk connected to the on
> board SIL3114 controller.
>
> I have the follwoing partitioning.
> /boot about 128 MB
> swap about 2 GB
> /root about 60GB
> /home about 20GB
>
> Is this OK or is there also a track maximum for FILO like existed for
> LILO?
> Is it best to configure FILO with grub commands?
>
> Regards,
>
> Joop.