On Jan 13, 2008 10:08 PM, Jouni Mettälä jtmettala@gmail.com wrote:
On Jan 12, 2008 7:24 PM, Peter Stuge peter@stuge.se wrote:
On Sat, Jan 12, 2008 at 02:15:34PM +0200, Jouni Mettälä wrote:
LinuxBios booted to filo. Motherboard is abit be6. This is azza/pt-6ibd/ config using http://coreboot.org/AZZA_PT-6IBD_Build_Tutorial. filo config was also from it.
Cool!
FILO doesn't find a hard drive at hda. Do you have one there?
Either way, it would be nice if you could use memtest as payload and let it run for a few hours to check that RAM is set up right.
//Peter
It now boots with filo. This time with different filo Config file. # means these lines were commented out.
#USE_GRUB = 1 MENULST_TIMEOUT = 6 -> = 10 VGA_CONSOLE = 1 -> VGA_CONSOLE = 0 PC_KEYBOARD = 1 -> PC_KEYBOARD = 0 #SUPPORT_PCI = 1 #PCI_BRUTE_SCAN = 1 added DEBUG_ALL = 1
using single 64M chip memtest was ok after 20 minutes. If longer time is needed then I test new version of memtest. Reading supported motherboards azza/pt-6ibd/ works also with 64MB it is marked as WIP.
Keyboard isn't working yet. Tested ps/2 keyboard. Using kernel as boot file it boots. I can't log in with keyboard or minicom. This could be something simple I don't now. Writing of boot line works with minicom.
I can confirm. It has been reported by me a while ago: http://www.coreboot.org/pipermail/coreboot/2007-December/028256.html People on IRC tried to help me, but the problem still remains.
Did you use flashrom on this board? It didn't work for me, and I had to use uniflash in dos.