Re: read the source ron!

[ron minnich]

On Thu, 2 Oct 2003, Andrew Ip wrote:
> Hi,
>
> Kevin did this fine job in v1.  Basically it assigns irqs for PCI devices
> in case of PIRQ table doesn't work.  I have been using in different
> place.  I also think it would be nice to do it in config file instead
> of in source just like geode.  Ron, does epia work now?

I'm not getting any ethernet interrupts. The packets get out, they get 
responsded to, but the node never gets the interrupt.

Also, I get these messages after a while:
eth0: Transmit timed out, status 1003, PHY status 786d, resetting...

I assume this means no TX IRQ. Blast. What do I look for?

ron