Hi Luc, Can you check that you have the following lines in mainboard/via/epia/Options.lb
use CONFIG_CONSOLE_SERIAL8250
default CONFIG_CONSOLE_SERIAL8250=1
I had a similar problem until I added these.
You should see LB getting a little further.
Regards Mark Wilkinson
Quoting Luc Belliveau luc@bigdata.nb.ca:
I compiled from freebios2 from cvs, when I boot all I get back from the serial port is:
LinuxBIOS-1.1.7.0Normal <date> starting.. vt8601 init starting Slot 00 is SDRAM 04000000 bytes x2 Slot 01 is empty Slot 02 is empty Slot 03 is empty vt8601 is done
that's it. I tried changing the DEFAULT_CONSOLE_LOGLEVEL but when I do that the resulting rom stops at Slot 00 is SDRAM 04000000 bytes x2.
I can't add uses DEFAULT_CONSOLE_LOGLEVEL or option DEFAULT_CONSOLE_LOGLEVEL in the Config.lb file either, the buildtarget scripts shuns it.
I'm using FILO as the payload, with no vga bios yet.
Could it be a FILO problem? I've never seen linuxBIOS before yesterday so I don't know what should be appearing on the terminal..
Any assistance would be appreciated :)
Luc _______________________________________________ Linuxbios mailing list Linuxbios@clustermatic.org http://www.clustermatic.org/mailman/listinfo/linuxbios
---------------------------------------------------------------- This message was sent using ISPMailNow.com