Re: [coreboot] å›žå¤ : Advice how to install Linux to get it working with FILO

[Qing Pei Wang]

hi Joop,
  From the log, the filo worked fine. it can detect the hard disk,load
kernel. But the kernel crashes.  i do not not much about why it crashed, how
about try to disable acpi?

On Wed, May 19, 2010 at 2:11 PM, Joop Boonen  wrote:
> On Wed, May 19, 2010 1:46 am, [e-mail] wrote:
> > Hi
> > Grub command is fine, what is your problem about filo?  send the log if
> > you can
>
> The problem is that I see the follwoing in the log:
>
> <quote>
> Jumping to entry point...
>
> INIT detected from  --- { APICID = 00 NODEID = 00 COREID = 00} ---
>
> Issuing SOFT_RESET...
>
> </quote>
>
> I've also attached the log.
> > Wang Qing Pei
> > Mail: [e-mail]
> > Phone:86+013426369984
> >
> > ----- Reply message -----
> > 发件人： "Joop Boonen" 
> > 日期： 周三, 5 月 19 日, 2010 年 07:09
> > 主题： [coreboot] Advice how to install Linux to get it working with
> > FILO
> > 收件人：
> >
> > Hello All,
> >
> > I want to get FILO working on my system (arima/hdama).
> > As I want to rule out my Linux installation I have a few questions.
> > I've installed openSuSE 11.2 x86_64 on a SATA disk connected to the on
> > board SIL3114 controller.
> >
> > I have the follwoing partitioning.
> > /boot about 128 MB
> > swap about 2 GB
> > /root about 60GB
> > /home about 20GB
> >
> > Is this OK or is there also a track maximum for FILO like existed for
> > LILO?
> > Is it best to configure FILO with grub commands?
> >
> > Regards,
> >
> > Joop.