If FILO is a payload in flash, then you need to set CONFIG_ROM_STREAM=1 and CONFIG_ROM_STREAM_START to the address you want to start looking for the payload ELF header (usually just after the LinuxBIOS image). CONFIG_IDE_STREAM is used to load a payload (such as FILO) from an attached IDE device. This is useful if the flash is not large enough to hold LinuxBIOS+payload, but is probably not what you are looking for. Sorry for the confusion.
Greg
On Nov 25, 2004, at 5:40 AM, Gin wrote:
I use FILO as the payload to boot from a Hard Disk, which has a installed linux on it. I noticed if I enabled the ide stream. It tries to read the ELF header from my IDE drive. But I thought the FILO payload should be the one to load the image from the IDE drive. When does it come in and play the role? Anyone can explain the flow of booting if I try to load the INSTALLED linux from a IDE drive.
Gin
Linuxbios mailing list Linuxbios@clustermatic.org http://www.clustermatic.org/mailman/listinfo/linuxbios