I add one printf if tg3.c to produce "err=?".
YH
-----邮件原件----- 发件人: Eric W. Biederman [mailto:eric@lnxi.com] 代表 Eric W. Biederman 发送时间: 2003年8月16日 10:18 收件人: Etherboot-users 抄送: YhLu; 'linuxbios@clustermatic.org'; Jeff Noxon 主题: Re: s2885
Guys the etherboot users list is really the right forum for this kind of question.
Jeff Noxon jeff@planetfall.com writes:
I can't get it to work with a 3com 3C996T (14e4:1644) ... it
recognizes
the card but thinks there's no cable plugged in.
I don't know. When the link detection code was written it was tested and it worked here. Except when the link really is not connected I have not seen code like that fail forever.
On Fri, Aug 15, 2003 at 10:31:44PM -0700, YhLu wrote:
Eric,
Is ethboot 5.2.0 support Broadcom 5703X? (deviceid = 0x16a7).
For the S2885's onboard 5703X, it says: EBUSY err.
Looking at the code it is should work. I just stripped down the appropriate driver. I do admit I have not tested 5.2 yet. But I don't see why anything would have broken.
Regards
Yinghai Lu
01:09.00 [14E4/16A7] [tg3-5703X]The PCI BIOS has not enabled this device! Updating PCI command 0002->0007. pci_bus 01 pci_device_fn 48 Capability: 7 Capability: 1 err=-1 Problem fetching invariants of chip, aborting.
Hmm. I have once or twice seen the problem of fetching invariants of the chip. But something is noticeably different from the tree I have because I do not have an line that will print err=-1 in the tree I am looking at.
Eric