On Monday 29 May 2006 20:26, Stefan Reinauer wrote:
- Juergen Beisert juergen127@kreuzholzen.de [060529 18:37]:
With write enabled E and F segments this message changes to: .... Devices initialized Copying IRQ routing tables to 0xf0000...done. Verifing copy of IRQ routing tables at 0xf0000...done Checking IRQ routing table consistency... check_pirq_routing_table() - irq_routing_table located at: 0x000f0000 done.
Can you provide a patch?
Yes, attached. But I'm not sure if this is the right place to patch. Maybe there is a better place to enable this feature?
But it still hangs after downloading the Linux kernel :-(
Have you enabled serial console in your kernel config? and did you specify it on the kernel command line? (ie. console=ttyS0,115200n8)
Yes I did. Its not my first embedded target that I bring up (but my first with LinuxBios). So that was the first I care for. The UART address seems ok, so I think Linux can find and use this device.
Regards
Juergen