Re: [coreboot] [PATCH 4/5] artecgroup/dbe61: Get DBE61A RAM setup and timing working.

[Carl-Daniel Hailfinger]

On 13.11.2008 01:19, Mart Raudsepp wrote:
> artecgroup/dbe61: Get DBE61A RAM setup and timing working.
> Uncomment the dbe61a SPD table
> Modify spd_read_byte to support a DIMM SPD address at DIMM_DBE61A that outputs data from dbe61a SPD table instead of dbe61c; approach tip from Marc Jones
> In main() after setting up DBE61C 256MB RAM, run a ram_check, and if that returns a greater than zero verify error count set up 128MB for DBE61A instead
> Tweak the dbe61a SPD table to result in LX MSR values as known to work in Artec v2 branch - this is DBE62/DBE61C values, with density and NUM_COLUMNS halved, and some timings tweaked according to the v2 results.
>
> Now memtest86+ is quite happy on both DBE61C and DBE61A.
>
> Note that it should be better to ram_check in the high memory areas, but that doesn't seem to currently work.
> Low memory check seems fine for the immediate time being, as the results appear shifted there as well with the wrong size/timing setup.
>
> Signed-off-by: Mart Raudsepp

Good enough for now.
Acked-by: Carl-Daniel Hailfinger

Regards,
Carl-Daniel