Eric Poulsen schrieb:
I'm trying to get the VGA console working. I've been looking through the email archives without much success, then I found this page:
http://linuxbios.org/index.php/VGA_support
I have a Via Epia ML5000 board.
Note that the ML Board is slightly different from the M board and target, e.g. firewire, cardbus and second raiser card support is missing.
You should prepend an original VGA BIOS from and old VIA M 1.13 BIOS: http://www.via.com.tw/download/mainboards/1/0/i0100113.bin You can extract the VGA image from the BIOS image with Award BIOS Editor: http://awdbedit.sf.net
You might have a look into my pdf document where the setup is described: http://archiv.tu-chemnitz.de/pub/2006/0066/data/studienarbeit.pdf Please read section 4.2.1
Also have a look into my patches under ./bios/linuxbios/install/patches/ of http://archiv.tu-chemnitz.de/pub/2006/0066/data/dateien.tar.gz Some of the changes you might consider useful for the ML board.
/1. in MB Config.lb You need to specify for your onboard VGA / /device pci 9.0 on # PCI / chip drivers/pci/onboard device pci 9.0 on end register "rom_address" = "0xfff80000" #512k image #register "rom_address" = "0xfff00000" #1M image end end/
I did not change anything of this section.
I can confirm that factory VGA is working with LinuxBIOSv2 r2169 on an EPIA ML-6000EA board. The only remaining problem is that after any kernel soft "reboot", the screen content is crippled and the machine hangs. After each hard reset or power cycle the machine starts fine.
HTH, Daniel.