USB support status:
For OHCI (AMD8111) support, it can do ED-TD process well.
Only one problem left:
When it using bulk transfer (ed 1 and 2) to talk to the USB disk, it gets the USB ERR 5, that means device does not response. But control ed (0) works well, can get the USB disk serial number.
Regards
YH
sector= 0 SUB URB:[00003c08] dev:2,ep:2-O,type:BULK,flags:00000000,len:0/31,stat:0(00000000) ohci.c: data(0/31): 00000055 00000053 00000042 00000043 00000009 00000003 00000000 00000000 00000000 00000002 00000000 00000000 00000080 00000000 0000000a 00000028... stat:0 td_fill 4 ed->dma=efe835e0, ed->hwHeadP=efe82ee0, ed->hwTailP=efe82f10 ohci->hcca->done_head = efe82ee0 ohci->hcca=fffff3d0 ohci=00071604 ohci->regs->donehead=00000000 td_list_hc = efe82ee0 USB-error/status: 00000005 : ffffe7b0
-----邮件原件----- 发件人: Jay Miller [mailto:jmiller@actuality-systems.com] 发送时间: 2004年5月27日 11:57 收件人: YhLu; ebiederman@lnxi.com 抄送: LinuxBIOS 主题: RE: Getting Started with freebios2!
I think that I've been lucky using a stock RH9 distro. I'm going to make sure I've got the latest binutils, etc... and retry.
By the way, what is the status on USB support? I know you were getting close.
Thanks, J
-----Original Message----- From: YhLu [mailto:YhLu@tyan.com] Sent: Thursday, May 27, 2004 3:10 PM To: ebiederman@lnxi.com; Jay Miller Cc: LinuxBIOS Subject: 答复: Getting Started with freebios2!
Did you use export LANG=en_US before make bin/tg3--filo.zelf?
Or I could send one tg3_filo.zelf to you?
Regards
YH
-----邮件原件----- 发件人: ebiederman@lnxi.com [mailto:ebiederman@lnxi.com] 发送时间: 2004年5月27日 11:48 收件人: Jay Miller 抄送: Eric W. Biederman; LinuxBIOS 主题: Re: Getting Started with freebios2!
"Jay Miller" jmiller@actuality-systems.com writes:
That's why I thought that elfboot couldn't read .zelf, because the image sizes are incorrect. Actual image size for the tg3--filo.zelf image is 43,153 bytes, which is smaller than the file.elf image 43,472 bytes. But when I make a linuxbios.rom with the tg3--filo.zelf as the payload, elfboot generates the output I sent you.
Run ``readelf -h -l'' on the problem image to see what the values are before it is combined into LinuxBIOS. I suspect you have a build problem, possible a messed up version of perl installed.
Eric _______________________________________________ Linuxbios mailing list Linuxbios@clustermatic.org http://www.clustermatic.org/mailman/listinfo/linuxbios