4 Nov
2009
4 Nov
'09
1:48 p.m.
Attached is the latest output. I don't see the errors anymore. I just tried booting Linux with the latest rom and it booted.
--
Hugh Greenberg
Myles Watson wrote:
>
>
> On Wed, Nov 4, 2009 at 12:06 PM, Hugh Greenberg <hng@lanl.gov
> mailto:hng@lanl.gov> wrote:
>
> Myles,
>
> It worked. Coreboot boots with SB_HT_CHAIN_ON_BUS_0 set to one
> and the previous patch. Seabios also detects the network devices
> without setting CONFIG_PCI_ROOT1 to 0x02. Attached is the output.
> Seabios was compiled with DEBUG_LEVEL set to 8.
>
>
> ERROR - cound not find bus for node 0 chain 0, using defaults
> ERROR - could not find PCI 1:01.0, using defaults
> ERROR - could not find PCI 1:02.0, using defaults
> Wrote the mp table end at: 000f0410 - 000f05e4
> Adding CBMEM entry as no. 3
> Looking for bad PCIX MHz input
> Looking for bad Hot Swap Enable
> OK 133MHz & Hot Swap is off
> ERROR - cound not find bus for node 0 chain 0, using defaults
> ERROR - could not find PCI 1:01.0, using defaults
> ERROR - could not find PCI 1:02.0, using defaults
> Wrote the mp table end at: 3fff1410 - 3fff15e4
>
> It almost worked. Can you try the attached patch?
>
> Is it actually booting into Linux?
>
> Thanks,
> Myles
>
>