I'm no expert on this board.
TC Init PNP: 004e.4 init PNP: 004e.5 init PCI: 00:1f.2 init SATA init SATA Enabled PCI: 00:1f.4 init APIC_CLUSTER: 0 init Initializing CPU #0 CPU: vendor Intel device 10650 CPU: family 06, model 15, stepping 00 Enabling cache
Setting fixed MTRRs(0-88) Type: UC
After this either it hang or jump back to "Uncompressing coreboot to RAM" and then hang. It can as well loop "Uncompressing coreboot to RAM".
Could it still be related to wrong timing value set on the memory controller? I doubt about this because I have tried a lot of different DIMMs as well but the result same. Memory can be ECC or not, not much differences.
I don't think so. This is a long time after RAM gets set up.
I've tried both FSB (400 and 533MHz) and both SKU ( 600 and 1200MHz (forced to 1060 as well).
What I can say as well is that depending where the PCIe GFX card is connected the boot process is very unstable. I know the build does not even use GFX output. Connecting the GFX card on the x16 PCIe slot is the more stable vector. By more stable I mean no strange unhandled exceptions.
I think more information here could be helpful.
I was trying to find in the sources where the hardware watchdog timer is enabled or disabled. Am not sure if this is something you have been taking care about during your dev or not, did you enable and set a value in the WDT or not.
To see if the problem is the WDT, set the log level lower (less output) and see if it reboots at a different place. It will boot much faster with less output.
A last thing is a bit before in the log is the following :
...
set power on after power fail RTC Init
The power did not fail, the voltage did not even drop, I've been measuring this with an oscilloscope in here. Is it expected?
I think this line means that it's setting the option, so that when there is a power failure it will power back on. It doesn't mean that there's been a power failure.
Thanks, Myles