-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA256
On 12/10/2018 07:48 PM, Taiidan@gmx.com wrote:
Applicable to: SP5100 AMD C32/G34 systems such as the KCMA-D8 and KGPE-D16.
Situation: If you don't have OpenBMC installed you need to run pwmconfig/fancontrol to manage fan speeds.
Problem: Normally the hwmon paths will change almost every boot resulting in the need to run pwmconfig repeatedly or fix them manually in /etc/fancontrol
- this was driving me nuts so I searched for and found a solution.
Solution: Create a .conf file in /etc/modprobe.d/ to set sensor module load order with these contents then reboot and fix the hwmon paths in your /etc/fancontrol, reboot again and all should be well :D
softdep fam15h_power pre: k10temp softdep k10temp pre: jc42 softdep jc42 pre: w83795g softdep w83795g pre: radeon
We should probably create a board documentation tips/tricks section in GIT since the Wiki is no longer available.
Side note: I still wish there was an easier way to do this; I never bothered transferring documentation to GIT because of the added time / complexity vs. the Wiki WYSIWYG editor.
- -- Timothy Pearson Raptor Engineering +1 (415) 727-8645 (direct line) +1 (512) 690-0200 (switchboard) https://www.raptorengineering.com