artecgroup/dbe61: Set up NAND and USB power handling settings
Also upper-cases the hex in lpc_serirq_polarity as all other Geode boards have it as such, and remove parts of the commented out reference v2 setup block that should be handled by this change now.
Oddly enough the USB power handling setting (that was to get the other pair of USB ports powered during DBE62 work) actually make memtest work, while without it it gets unexpected interrupt halts. The SPD commit earlier missed this local change as an unrelated one.
Signed-off-by: Mart Raudsepp mart.raudsepp@artecdesign.ee --- mainboard/artecgroup/dbe61/dts | 15 +++++---------- 1 files changed, 5 insertions(+), 10 deletions(-)
diff --git a/mainboard/artecgroup/dbe61/dts b/mainboard/artecgroup/dbe61/dts index 69a6217..291764a 100644 --- a/mainboard/artecgroup/dbe61/dts +++ b/mainboard/artecgroup/dbe61/dts @@ -22,14 +22,8 @@
/* chip southbridge/amd/cs5536_lx - register "enable_ide_nand_flash" = "0" - - register "isa_irq" = "0" #register "flash_irq" = "14"
- ## IDE IRQ - register "enable_ide_irq" = "0" - register "audio_irq" = "5" register "usb_irq" = "7"
@@ -55,9 +49,6 @@ # Configure KEL Emulation IRQ, 0 to disable register "kel_emul_irq" = "0"
- device pci f.0 on end # ISA Bridge - device pci f.1 on end # Flash controller - device pci f.2 off end # IDE controller device pci f.3 on end # Audio device pci f.4 on end # OHCI device pci f.5 on end # EHCI @@ -95,12 +86,14 @@ end * Each bit is an IRQ 0-15. */ lpc_serirq_enable = "0x00001002"; /* LPC IRQ polarity. Each bit is an IRQ 0-15. */ - lpc_serirq_polarity = "0x0000effd"; + lpc_serirq_polarity = "0x0000EFFD"; /* 0:continuous 1:quiet */ lpc_serirq_mode = "1"; /* GPIO(0-0x20) for INT D:C:B:A, 0xFF=none. * See virtual PIC spec. */ enable_gpio_int_route = "0x0D0C0700"; + /* 0:IDE; 1:FLASH on CS0, 2:FLASH on CS1, 3:FLASH on CS2, 4:FLASH on CS3. */ + enable_ide_nand_flash = "2"; /* COM1 settings */ com1_enable = "0"; com1_address = "0x2f8"; @@ -109,6 +102,8 @@ end com2_enable = "1"; com2_address = "0x3f8"; com2_irq = "4"; + /* USB Port Power Handling setting. */ + pph = "0xf5"; }; pci@f,2 { /config/("southbridge/amd/cs5536/ide");