Re: [coreboot] Fwd: Ethernet problem in x200

[Nico Huber]

Hi,

please always keep the mailing list in CC.

On 27.03.2017 16:48, serdar tunc wrote:
> Should i change cbfs size? I tried doing that but my problem still occurs

If my suspicion below is correct, your problem is not related to core-
boot. It's about firmware parts that share the flash chip with coreboot.
The first part is a descriptor that holds a table of regions, your CBFS
should match the BIOS region in size.

I advice you to never flash more than one (untested) region at once. It
makes troubleshooting harder, since you won't know otherwise which re-
gion causes problems.

Nico
> 27 Mar 2017 17:33 tarihinde "Nico Huber"  yazdı:
> > Hello Serdar, Zoran,
> >
> > On 27.03.2017 16:14, Zoran Stojsavljevic wrote:
> > > [user@localhost projects]$ cat dmesg.txt | grep 00:19.0
> > > [    0.151652] pci 0000:00:19.0: *[8086:294c*] type 00 class 0x020000
> > > [    0.151694] pci 0000:00:19.0: reg 0x10: [mem 0xe1600000-0xe161ffff]
> > > [    0.151707] pci 0000:00:19.0: reg 0x14: [mem 0xe1624000-0xe1624fff]
> > > [    0.151721] pci 0000:00:19.0: reg 0x18: [io  0x3000-0x301f]
> > > [    0.151802] pci 0000:00:19.0: PME# supported from D0 D3hot D3cold
> > > [    1.489719] e1000e 0000:00:19.0: Interrupt Throttling Rate (ints/sec)
> > > set to dynamic conservative mode
> > > [    1.611526] e1000e 0000:00:19.0: The NVM Checksum Is Not Valid
> >
> > I can't say for sure, but this looks much like the GbE and/or Firmware
> > Descriptor regions of the BIOS flash are corrupted. If in doubt, you can
> > generate a layout file for flashrom from the backup of the vendor BIOS
> > with `ifdtool -f` (see util/ifdtool/ in the coreboot tree). And flash
> > back these selected regions with `flashrom -l layoutfile -i fd -i gbe
> > ...` from the backup.
> > > *[    1.635873] e1000e: probe of 0000:00:19.0 failed with error -5*
> > > [user@localhost projects]$
> >
> > Hope that helps,
> > Nico