off-topic part 2: PIC and ETRAX [was: Memtest+]

[Dave Aubin]

      Again Peter, very nice:)

I will give you one more tid bit as it consumes less power than the
Axis, but still runs Linux and is quite small:)
Check out: http://www.brightstareng.com/
They have entire set ups on a form factor less than a credit card
Running Linux:)  Although it is still not a PIC, it is very good
For PIC type needs.

Thanks again,
Dave:)
 

-----Original Message-----
From: linuxbios-admin(a)clustermatic.org
[mailto:[e-mail]] On Behalf Of Peter Stuge
Sent: Thursday, December 30, 2004 2:54 PM
To: LinuxBIOS
Subject: Re: off-topic: PIC and ETRAX [was: Memtest+]

On Thu, Dec 30, 2004 at 02:25:47PM -0500, Dave Aubin wrote:
  Nice read Peter, thank you for the info:)
No problem!


  Would be nice to use some voltage reference
differencing Instead of 
 using a Max 232, but the Max is probably a cleaner approach.
The MAX232 is pretty common for connecting both PIC and AVR devices to
RS-232 equipment. It just needs a few external capacitors, which is
nice.


  A nerdy aside, I heard the 18F4550 and 18F2550 can run
up to 12MIPs 
 from a 4MHz crystal, they've got a whopping 16K of flash, and they 
 have a Full-Speed USB v2.0 hardware.
Yep. And 2kb RAM. Check out the data sheet page 11 and chapter 2.
http://ww1.microchip.com/downloads/en/DeviceDoc/39632b.pdf


  Now if I could only run Linux on a PIC;)
Linux? That's for the ETRAX, made by Axis. Check out
http://developer.axis.com/

Everything-is-included Linux chip with 10/100 and both NOR and NAND
flash for boot as well as storage. They've ported the GNU toolchain too.

I'm still waiting for some project where I can use the MCM and end up
with a few extra boards. :)


//Peter
_______________________________________________
Linuxbios mailing list
Linuxbios(a)clustermatic.org
http://www.clustermatic.org/mailman/listinfo/linuxbios