Hi Craft,
Looks like you only replied to me, so the mailing list hasn't received your message. In the future, remember to use "Reply to all" so that the mailing list also gets a copy of your message.
On Fri, Jul 22, 2022 at 12:10 AM J. Craft djcraft@gmail.com wrote:
Appreciate you getting back to me, Angel. Write Protection had been disabled, but I hadn't rebooted for it to take effect. :)
Yes, a reboot is needed for the write-protect settings to be updated.
However, after rebooting and flashing properly, it appears that there is a bug in the bios that causes an ACIP BIOS ERROR when trying to install Windows 10. Any suggestions on what to do in this situation?
Hmmm, https://www.reddit.com/r/chrultrabook/comments/aufp1q/getting_started_read_t... says that Nocturne should be able to boot Windows... I presume it's a regression of some sort.
Kind regards, Craft
On Thu, Jul 21, 2022 at 3:59 AM Angel Pons th3fanbus@gmail.com wrote:
Hi,
On Thu, Jul 21, 2022 at 2:23 AM J. Craft djcraft@gmail.com wrote:
Let me know if there's anything else needed and what might be suggested in this situation.
*snip*
0x84: 0x89ef09d0 PR0: Warning: 0x009d0000-0x009effff is read-only.
flashrom errors out because this region is read-only. I'm pretty sure that's the MRC cache region. You have to disable write-protect by either removing the "WP screw" or by disconnecting the internal battery, then you will be able to flash coreboot successfully.
Good, writing to the flash chip apparently didn't do anything.
You can safely reboot.
Best regards, Angel
Best regards, Angel
-
Angel Pons