On 05/05/08 23:03 -0700, ron minnich wrote:
I think 2.6.25 is hanging on the probe of ide port1.
This is 2.6.24
AMD5536: IDE controller (0x1022:0x209a rev 0x01) at PCI slot 0000:00:0f.2 AMD5536: not 100% native mode: will probe irqs later AMD5536: 0000:00:0f.2 (rev 01) UDMA100 controller ide0: BM-DMA at 0x1ca0-0x1ca7, BIOS settings: hda:pio, hdb:pio AMD5536: IDE port disabled hda: CF 1GB, ATA DISK drive hda: MWDMA2 mode selected ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 hda: max request size: 128KiB hda: 2030112 sectors (1039 MB) w/1KiB Cache, CHS=2014/16/63 hda: hda1
and 2.6.25
AMD5536: 0000:00:0f.2 (rev 01) UDMA100 controller AMD5536: IDE controller (0x1022:0x209a rev 0x01) at PCI slot 0000:00:0f.2 AMD5536: not 100% native mode: will probe irqs later AMD5536: IDE port disabled ide0: BM-DMA at 0x1ca0-0x1ca7, BIOS settings: hda:PIO, hdb:PIO
and on one boot it did this: Probing IDE interface ide1...
I think it's going after ide1, even though it is not there. Not sure yet. Something is pretty wrong here, and it broke from 2.6.24 to 2.6.25.
Of course its looking for ide1, but as soon as it sees the missing bit in the PCI config space its going to give up.
I haven't been able to reproduce hangs with the legacy IDE driver running with v2 and 2.6.25 on norwich - everything is running fine:
AMD5536: 0000:00:0f.2 (rev 01) UDMA100 controller AMD5536: IDE controller (0x1022:0x209a rev 0x01) at PCI slot 0000:00:0f.2 AMD5536: not 100% native mode: will probe irqs later AMD5536: IDE port disabled ide0: BM-DMA at 0x1ca0-0x1ca7, BIOS settings: hda:PIO, hdb:PIO Probing IDE interface ide0... hda: TOSHIBA THNCF512MDG, CFA DISK drive hda: host max PIO5 wanted PIO255(auto-tune) selected PIO4 hda: host max PIO5 wanted PIO255(auto-tune) selected PIO4 ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 Probing IDE interface ide1...
pata_cs5536 is not healthy, however:
PCI: Unable to reserve I/O region #1:8@1f0 for device 0000:00:0f.2 pata_cs5536 0000:00:0f.2: failed to request/iomap BARs for port 0 (errno=-16) pata_cs5536 0000:00:0f.2: no available native port
Again, this is with v2, so your mileage will vary, but as far as the amd74xx driver is concerned, I don't think we're seeing a huge kernel regression. I'm going to take some swings at the pata_cs5536 driver and see if we can't make it better.
Jordan
PS: In my config, at least, following the IDE setup is the USB setup - possibly you are hanging _there_ and just not seeing any intermediate kernel messages.