-----Original Message----- From: coreboot-bounces+joe=settoplinux.org@coreboot.org [mailto:coreboot- bounces+joe=settoplinux.org@coreboot.org] On Behalf Of Uwe Hermann Sent: Friday, May 16, 2008 3:20 PM To: Joseph Smith Cc: Stefan Reinauer; coreboot@coreboot.org Subject: Re: [coreboot] v2[PATCH] Initial support for the Thomson IP1000
On Fri, May 16, 2008 at 10:49:48AM -0400, Joseph Smith wrote:
ACPI Exception (utmutex-0263): AE_BAD_PARAMETER, Thread C37D2000 could
not acquire Mutex [1] [20070126]
Looks scary, but probably harmless as you don't have ACPI.
Yes I think this is just because there is no ACPI. What is mutex anyways?
intel8x0_measure_ac97_clock: measured 50829 usecs intel8x0: clocking to 48000 loop: module loaded IRQ handler type mismatch for IRQ 6 current handler: uhci_hcd:usb3 [<c045abd0>] setup_irq+0x194/0x1ac [<c41ef2de>] floppy_hardint+0x0/0xd8 [floppy] [<c045ad82>] request_irq+0xc7/0xe5 [<c417d665>] init_module+0x536/0xe33 [floppy] [<c061bfb6>] cond_resched+0x26/0x31 [<c044917d>] __link_module+0x0/0x10 [<c044917d>] __link_module+0x0/0x10 [<c044a80f>] sys_init_module+0x1361/0x14a5 [<c04e812c>] blk_init_queue+0x0/0x8 [<c040518a>] syscall_call+0x7/0xb [<c0610000>] xfrm_send_policy_notify+0x35c/0x4fd ======================= floppy0: Unable to grab IRQ6 for the floppy driver
This doesn't look too good(?)
Not sure why this happens. You do disable floppy in Config.lb via "device pnp 2e.0 off" (but maybe the stuff between that line and the corresponding "end" has to be dropped? Not sure...
Yeh this started when I updated the kernel there is no floppy and it is disabled so not sure either... maybe a gpio setting?
Can you post 'superiotool -dV' from BIOS and coreboot for comparison?
Sure, will do.
Also, your PIRQ table is the same as for RCA RM4100, is that really the case? I.e. have you compared the getpir output of both?
It should be the same except as Corey said there is a PCI slot that needs to be added. Linux was never able to run on this box until now, so I don't really have any way to run getpir with the original bios.
python[2050] general protection eip:a78d15 esp:bffec260 error:0
?
Not sure about that one either.
Thanks, Joseph Smith Set-Top-Linux www.settoplinux.org