Hallo Vladimir, Peter and Stefan
thank you for your emails! You already helped me alot. I don't expect to successfully
close this project in a fast run and I'm willing to learn a number of tools.
At the moment I am still collecting hardware informations about this computer. I
dissembled it completely and documented the chip names of what I thought might be of
interest. Please see http://macbook.donderklumpen.de/coreboot/
for what I got. My biggest
concern is with the EC. It is a Renesas H8S/2116V. I read about this chip that it makes
coreboot impossible on other machines, but I do not know whether this issue is machine
specific, or if the chip definitely makes coreboot impossible for this macbook too. Could
you comment on this? Also I do not know yet how I could verify whether the EC shares
memory with the main system.
As for the ability of flashing the EPROM chip, I plan to test it in the near future (at
first with an empty brand new chip, then with the soldered one). The EPROM is supported by
flashrom and I plan to use a Beaglebone Black to be the programmer. (this page shows
Beaglebone Black can flash a chip via SPI also flashrom is not used here:
) I already learned how to use the Beaglebone Black to debug what coreboot outputs to the
USB port on a Thinkpad X60. I assume this should work the same for the macbook (the debug
port at the macbook seems to exist, but the factory BIOS does not write anything to it).
One more question: The macbook atm uses a 32bit EFI which when it was purchased booted a
32bit kernel, and today boots a 64bit linux-libre kernel. Would I need to expect any
additional problems from the fact that it is not a traditional BIOS, but some EFI which is
to be replaced? My optimistic wish is to replace that EFI with coreboot plus a 64bit GRUB2
payload (same as done on my Thinkpad X60). Or would the payload need to be kept at 32bit?
thanks again and
with best regards
On Wed, Jan 29, 2014 at 10:24:58PM +0100, Stefan Reinauer wrote:
* Mono <mono(a)posteo.de> [140124 23:20]:
Would you help me on a coreboot port? I just installed coreboot on a Thinkpad X60
following the wiki. Now I want it on this mid-2007 macbook2,1 too.
I read some pages in the wiki and started to collect information about the macbook. it
seems it has no superIO chip and I dont know what to think of the ectool output. As I
understood by now, not knowing how the ec might interfere with the bios or coreboot is one
of the big obstacles, no? I hope that once I would try a coreboot flash, recovery might be
possible by an external programmer (which I do not have, yet). the flash chip is the same
as on the X60 (I've read the factory bios already) as is the northbridge and
southbridge. an usb debug port seems available.
I've put the log files here: http://macbook.donderklumpen.de/coreboot/
Any comment about what you think about this and how I should proceed is very much
- Make sure you have the external tools in place to recover from a bad
flash. You will not boot successfully on the first attempt.
- Keep a copy of the original firmware around
- Try to make sure that your USB debug gadget is working before starting
- Start with one of the existing i945 based notebooks
- find out what EC is used, and if it shares flash with the main system
- try to get hold of schematics
coreboot mailing list: coreboot(a)coreboot.org