Re: [coreboot] SST49LF008A on amd/db800

[Phani Babu Giddi]

Looks like on the board the Boot Options are hardwired to FWH so all that I
need to do would be to increase the ROM size and it should work. 49LF004B
works both in FWH mode and also in LPC mode.

-Phani

On Fri, Feb 22, 2008 at 2:14 PM, Marc Jones  wrote:
> Phani Babu Giddi wrote:
> > Hello All,
> >
> > I am planning to use the BIOS chip SST49LF008A instead of SST49LF004B on
> > AMD's Geode LX 800 development board DB800. Do you think this will work
> > without changing any optiong in Config.lb http://config.lb/ <
>
> http://Config.lb http://config.lb/> for this
> > board. 49LF004B is based on LPC while 49LF008A is based on FWH. I had to
> > change the part because LPC interface based chip by SST has been EOLed.
>
> If you change the size (8A is 1Mb and 4B is 512KB right?) you will need
> to make an adjustment in the target/../config.lb in order to get the
> correct ROM size.
> option ROM_SIZE=1024*1024-36*1024
> > The best way for me would have been to test it and find it out myself
> > but currently coreboot build is failing on Fedora 8 based system even
> > after applying the rececent patches and updates to LD.
>
> I will take a closer look at the failure you sent.
> > I am just curious does CS5536 has to be initalized in a differently to
> > be able to boot from FWH ?
>
> You will need check cs5536 boot straps are set to FWH. You can check it
> in this MSR:
>
> 6.6.2.10 Ball (Pin) Options Control (DIVIL_BALL(PIN)_OPTS)
> MSR Address 51400015h
> Type R/W
> Reset Value 00000x7xh
>
> Marc