You can enable debug in filo. Also add some printf in ide_disk.c
YH
-----Original Message----- From: linuxbios-admin@clustermatic.org [mailto:linuxbios-admin@clustermatic.org] On Behalf Of Luc Belliveau Sent: Saturday, December 04, 2004 9:32 AM To: Ronald G. Minnich Cc: linuxbios@clustermatic.org Subject: Re: epia problem/Epia status update
Here is the output from lspci on my board
*00:00.0 Host bridge: VIA Technologies, Inc. VT8601 [Apollo ProMedia] (rev 05) 00:01.0 PCI bridge: VIA Technologies, Inc. VT8601 [Apollo ProMedia AGP] 00:11.0 ISA bridge: VIA Technologies, Inc. VT8231 [PCI-to-ISA Bridge] (rev 10) 00:11.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06) 00:11.2 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 1e) 00:11.3 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 1e) 00:11.4 Bridge: VIA Technologies, Inc. VT8235 ACPI (rev 10) 00:11.5 Multimedia audio controller: VIA Technologies, Inc. VT82C686 AC97 Audio Controller (rev 40) 00:12.0 Ethernet controller: VIA Technologies, Inc. VT6102 [Rhine-II] (rev 51) 01:00.0 VGA compatible controller: Trident Microsystems CyberBlade/i1 (rev 6a) * What did you want me to double check about my IDE exactly? I haven't changed any of the defaults in LinuxBIOS with the exception of the CONFIG_CONSOLE_SERIAL8250 and the loglevels.
Luc
Ronald G. Minnich wrote:
ok, just double check that your ide is right, and can somebody send me an lspci for these boards? I don't have one handy.
Finally, I do know that native ide mode was always buggy on this part. Is that a possibility here?
ron
_______________________________________________ Linuxbios mailing list Linuxbios@clustermatic.org http://www.clustermatic.org/mailman/listinfo/linuxbios