17 Apr
2007
17 Apr
'07
3 p.m.
On Tue, Apr 17, 2007 at 02:45:53PM +0200, ST wrote:
Hi
Could you try also with a resistor, instead of shorting directly to ground? About 10k. That would be nicer to the chipset output drivers. (I wanted to desolder the pin completely for that reason too.)
I'm am only shorting the *input* pin #init to ground
Yes, I'm talking about the output driver, in the chipset, that is connected to INIT#.
which is pulled up by a pull-up resistor (which i didn't found).
Aha. Did you measure a resistance to Vdd? If the chipset output is open collector then I'm worried for no reason. :)
But i will post s.t. detailled with images and stuff so anyone with little solder experience can do it herself.
Nice, thanks!
//Peter