* Uwe Hermann uwe@hermann-uwe.de [071014 19:10]:
See patch.
This patch should also fix the broken abuild-run on this board...
Thanks, Uwe.
Some fixes for the BCOM WinNET100, mostly in Config.lb:
Add missing entry for the NIC:
device pci 0f.0 on end # Ethernet (onboard)
Drop the following lines:
register "com1" = "{115200}" register "com2" = "{38400}"
Those entries hardcode the BAUD rate (as far as I can tell, please correct me if I'm wrong). We don't want that -- instead the config option TTYS0_BAUD in Options.lb should be used(?) I verified that dropping those lines will not break serial output (COM1, 115200, 8n1).
Enable IDE (PCI device 00:12.2) and add the following register lines to tell the CS5530 code to actually enable IDE channel 0:
register "ide0_enable" = "1" register "ide1_enable" = "0" # Not available/needed on this board
Tested with a 2.5" hard drive and FILO, works fine.
Enable USB (PCI device 00:13.0), not sure why it was commented.
Enable COM2 as it's used by the smartcard reader.
Add CONFIG_COMPRESSED_PAYLOAD_LZMA to Options.lb, in order to fix abuild for this board.
Add some more comments.
Signed-off-by: Uwe Hermann uwe@hermann-uwe.de
Acked-by: Stefan Reinauer stepan@coresystems.de