Re: [FILO] prompt doesn't work...

[SONE Takeshi]

On Thu, Sep 25, 2003 at 09:26:03AM +0900, [e-mail] wrote:
> I did build a filo with default config. ( make  & make )  
> serial debug message is like below. But I can't type any command.
> VGA Console prompt has also the same problem.
>
> My Board is likely to EPIA 5000.
>
> Does FILO use only PS/2 keyboard as Input Device Driver?

PS/2 (or AT) keyboard and serial port.
They must be enabled by LinuxBIOS.

For serial port, turn off all the flow control of your terminal.

It's fully tested with my EPIA 5000, so if you have the same board,
it should work.
Though it could be possible that your LinuxBIOS is configured
differently than mine.