Re: linuxbios on geode gx1 with sst-39SF020A and CompactFlash [PMX:#]

[Christer Weinigel]

ramesh bios  writes:
> So my current status is that I get as far as:
>
> <snip>
> Enable FLASH
> Set F0/0x52 to 0xee
> cs5530: Enabling Primary IDE Controller
> cs5530: Enabling Secondary IDE Controller
> Set F0/0x5b to |= 1 << 5(0x38)
> handle_superio start, nsuperio 1
> handle_superio: Pass 1, check #0, s 00009e00 s->super
> 0000a018
> handle_superio: Pass 1, Superio WinBond w83977tf
> handle_superio:  port 0x370, defaultport 0x3f0
> handle_superio:  Using port 0x370
>   Call init
> Enabling com device: 02
>   iobase = 0x03f8  irq=4
> þ³{Ìdþ̵»ï«EwLìoS»Ç7ÄoeÜöFFÆÎô¬ÇFo~¡çG޷Ǭ³{ÆãnãÞ÷ÞÆÎÎÌb;³þfÃÞov«\3Å·øLõGn¿d7ÃøL
> <snip>

This looks as if the baudrate is wrong.  If I remember correctly, up
until "Enabling com device" all output is via some hardcorded and
really dumb debug statements, after this the LinuxBIOS I/O system
takes over.  So check that the debug baudrate and that the baudrate
for the rest of LinuxBIOS is the same.

/Christer