ron minnich wrote:
With this patch to FILO: Index: i386/timer.c =================================================================== --- i386/timer.c (revision 35) +++ i386/timer.c (working copy) @@ -105,7 +105,7 @@ return (end - start) * CLOCK_TICK_RATE / (1000*LATCH); }
-static unsigned long long cpu_khz; +static unsigned long long cpu_khz = 500000; void setup_timers(void) { if (!cpu_khz) {
I just booted linux. First v3 boot on real hardware.
There are still problems. Linux is quite busy as revealed by a POST card but we don't seem to get interrupts. Things are not wired correctly.
I am attaching the console log as I think this is pretty important for v3 :-)
Wow, this was a long haul, but we are very close. Thanks to you all.
thanks
ron
You need good settings for the southbridge in your platform dts. You should be able to copy these from v2.
/* LPC IRQ polarity. Each bit is an IRQ 0-15. */ lpc_serirq_polarity = "0";
/* 0:continuous 1:quiet */ lpc_serirq_mode = "0";
/* GPIO(0-0x20) for INT D:C:B:A, 0xFF=none. See virtual PIC spec. */ enable_gpio_int_route = "0";
Marc