Hi,
With your elf I get the following: boot: uda1:/ram0_2.5_2.6.5_k8.2_mydisk7.elf LinuxLabs USB bootloader New USB device, setting address 2 00000008:00000006:00000050 Manufacturor: Kingston Product: DataTraveler2.0 Serial: 07B1F140E000617B Found USB block device 2 Mounted reiserfs errnum=15 boot: uda1:/ram.elf Loading Linux version 2.6.5 (root@tst288xsuse9) #11 SMP Mon May 10 14:58:17 PDT 2004... Jumping to entry point... DFA Just before C's xstart32 Firmware type: LinuxBIOS old bootloader convention, maybe loadlin? Bootdata ok (command line is root=/dev/ram0 rw console=tty0 console=ttyS0,115200n8) . . RAMDISK driver initialized: 16 RAM disks of 16384K size 1024 blocksize loop: loaded (max 8 devices) . . usb 2-3: new full speed USB device using address 2 scsi4 : SCSI emulation for USB Mass Storage devices Vendor: Kingston Model: DataTraveler2.0 Rev: 4.70 Type: Direct-Access ANSI SCSI revision: 02 SCSI device sda: 1019392 512-byte hdwr sectors (522 MB) sda: assuming Write Enabled sda: assuming drive cache: write through sda: sda1 Attached scsi removable disk sda at scsi4, channel 0, id 0, lun 0 NET: Registered protocol family 2 IP: routing cache hash table of 2048 buckets, 32Kbytes TCP: Hash tables configured (established 65536 bind 65536) NET: Registered protocol family 1 NET: Registered protocol family 17 RAMDISK: Compressed image found at block 0 RAMDISK: incomplete write (-28 != 1) 16777216 crc error EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended VFS: Mounted root (ext2 filesystem). Freeing unused kernel memory: 472k freed Kernel panic: No init found. Try passing init= option to kernel.
This makes me feel a little better as it appears it is something in my etherboot-filo configuration perhaps?
On Thu, 2004-07-08 at 17:53, YhLu wrote:
I wonder if it is after gzip or before gzip.
-----Original Message----- From: ron minnich [mailto:rminnich@lanl.gov] Sent: Thursday, July 08, 2004 2:44 PM To: David Aubin Cc: YhLu; LinuxBIOS Subject: RE: Filo Error Help
On Thu, 8 Jul 2004, David Aubin wrote:
If so could it be a size issue? My initrd is 8Meg.oh!
did you config the kernel for that? default is 4M.
ron